Skip to main content

Changes to Step #22

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* icon_note] There are six piecesIn the next steps, you will use an iOpener to apply heat to the rear case of strongthe iPad to soften adhesive tape holding the logic board onto the rear casein place.
[* black] Make sure you pryred] The adhesive is in the logic board offform of each piecesix pieces of tape. Use these imagesblack foam tape—refer to this step as a guideyou work at heating and prying to check that all adhesive has been severedkeep track of where each piece is located.
[* icon_note] There are six piecesIn the next steps, you will use an iOpener to apply heat to the rear case of strongthe iPad to soften adhesive tape holding the logic board onto the rear casein place.
[* black] Make sure you pryred] The adhesive is in the logic board offform of each piecesix pieces of tape. Use these imagesblack foam tape—refer to this step as a guideyou work at heating and prying to check that all adhesive has been severedkeep track of where each piece is located.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version