Skip to main content

Changes to Step #24

Edit by Evan Noronha

Edit approved by Evan Noronha

Before
After
Unchanged

Step Lines

[* icon_note] As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.
[* black] Carefully insert a guitaran opening pick under the logic board, between the front-facing camera and the battery.
[* black] Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.
[* black] Carefully insert a guitaran opening pick under the logic board, between the front-facing camera and the battery.
[* black] Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.