Skip to main content

Changes to Step #15

Edit by Sam Goldheart

Edit approved by Sam Goldheart

Deleted
Added
Unchanged

Step Lines

[* icon_note] The LCD and Digitizer connectors are on the same cable assembly, so prying the end up should disconnect both connectors. Make sure the two cables are fully disconnected before removing the display.
[* icon_note] The LCD and Digitizer connectors are on the same cable assembly, so prying the end up should disconnect both connectors. Make sure the two cables are fully disconnected before removing the display.
[* black] Pry up on the end of the LCD/Digitizer cable to disconnect both connectors.
[* icon_cautionicon_reminder] When reassembling your phone, Thethe LCD cable may pop off theits connector. This can cause white linesA blank screen, or nothing at all to appear when powering your phone back on. If that happens, simplywhite lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.
[* icon_cautionicon_reminder] When reassembling your phone, Thethe LCD cable may pop off theits connector. This can cause white linesA blank screen, or nothing at all to appear when powering your phone back on. If that happens, simplywhite lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.