Skip to main content

Changes to Step #15

Edit by Sam Goldheart

Edit approved by Sam Goldheart

Deleted
Added
Unchanged

Step Lines

[* icon_note] Theblack] Use a plastic opening tool to disconnect the digitizer cable.
[* icon_caution] The
LCD and Digitizer connectors are on the same cable assembly, so prying the enddigitizer connector up should disconnect both connectors. Make sureDouble check that the two cables are fully disconnected before removing the display.
[* black] Pry up on the end of the LCD/Digitizer cable to disconnect both connectors.
[* icon_note] Theblack] Use a plastic opening tool to disconnect the digitizer cable.
[* icon_caution] The
LCD and Digitizer connectors are on the same cable assembly, so prying the enddigitizer connector up should disconnect both connectors. Make sureDouble check that the two cables are fully disconnected before removing the display.
[* black] Pry up on the end of the LCD/Digitizer cable to disconnect both connectors.
[* icon_reminder] When reassembling your phone, the LCD cable may pop off its connector. A blank screen, or white lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.

Image 3

No previous image

Added