Skip to main content

Changes to Step #6

Edit by Arthur Shi

Edit approved by Arthur Shi

Before
After
Unchanged

Step Lines

[* black] Remove the following screws from the logic board:
[* red] One 2.4 mm Phillips #000 screw
[* icon_reminder] This screw also holds a small metal contact beneath the logic board. It's held in place underneath a plastic bracket, but if you see it slipping out, refer to [guide|20246|this step|stepid=72613|new_window=true] to remove it.
[* orange] Two 2.3 mm Phillips #000 screws
[* yellow] Four 2.8 mm standoff screws
[* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true]a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true]a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.