Skip to main content

Changes to Step #5

Edit by Jethro

Pending approval

Before
After
Unchanged

Step Lines

-[* red] NOTE: Here are the screw holes without the cooling unit installed to make it easier to understand where the screws are located
-[* yellow] Check the pin connections for any damage. All the pins highlighted in yellow should appear straight up and not appear bent.
+[* red] NOTE: Here are the standoffs without the cooling unit installed to make it easier to understand where the screws are located. Remove the bottom 2 standoffs so it is easier to remove the power supply.
+[* yellow] Check the pin connections for any damage. All the pins highlighted in yellow should appear straight up and not appear bent. DON'T TOUCH THE PINS. A ben pin will result in your computer not powering on.