Changes to Step #6
Edit by Arthur Shi —
Edit approved by Arthur Shi
- Before
- After
- Unchanged
Step Lines
| [* black] Pull the battery out of the rear case. |
| [* icon_note] If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the ribbon cable. |
| [* icon_reminder] Before you adhere the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess. |
| [* black] Adhere the battery, disconnect it, and continue reassembling your device. |
| [* icon_reminder] If your new battery doesn’t have adhesive preinstalled, refer to [guide|107792|this guide] to replace the adhesive strips. |
| [* icon_reminder] Perform a [guide|44496|hard reset] after reassembly. This can prevent several issues and simplify troubleshooting. |