Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #2

Edit by Sean Portune

Edit approved by Sean Portune

Deleted
Added
Unchanged

Step Lines

[* red] Remove the four 12mm Phillips #2 screws on the outer edge of the white case.
[* icon_caution] Be careful! There are two small, fragile, plastic tabs at the bottom of the device keeping it together that are subject to breakageeasily broken.
[* black] Once you removed thosethe screws, pick the device up suchso that the bottom grey label on the bottom of the device is on the upper half facing towards you. Slowly apply force to the bottom
[* black] With your thumbs on either side
of the casegrey label, slowly push with both thumbs until the case pops open.
[* icon_caution] Be careful! There are two small, fragile, plastic tabs at the bottom of the device keeping it together that are subject to breakageeasily broken.
[* black] Once you removed thosethe screws, pick the device up suchso that the bottom grey label on the bottom of the device is on the upper half facing towards you. Slowly apply force to the bottom
[* black] With your thumbs on either side
of the casegrey label, slowly push with both thumbs until the case pops open.
[* icon_note] A small gap will open as the two tabs are released.
[* icon_caution] The two halves are held together by the speaker wire, so do not pull them apart yet.