Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #2

Edit by Sean Portune

Edit approved by Sean Portune

Deleted
Added
Unchanged

Step Lines

[* red] Remove the four 12mm PH2 Phillips #2 screws on the outer edge of the white case.
[* red] Remove the four 12mm PH2 Phillips #2 screws on the outer edge of the white case.
[* icon_caution] Be careful! There are two small, fragile, plastic tabs on the inside at the bottom of the device keeping it together that are subject to breakage.
[* black] Once you removed those screws, pick the device up such that the bottom grey label is on the upper half facing towards you. Slowly apply force to the bottom of the case.
[* icon_note] A small gap will open as the two tabs are released.
[* icon_note] The two halves are held together by the speaker wire, so do not pull them apart yet.