Skip to main content

Changes to Step #13

Edit by Walter Galan

Pending approval

Before
After
Unchanged

Step Lines

[* black] Now that the lower edge of the board is free from the outer case, rotate the logic board toward yourself to expose its rear face.
-[* icon_caution] The following connector has a tendency to stick in its socket. If so, insert a metal spudger into the gap between the connecter and its socket. Twist the spudger to separate the two components.
+[* icon_note] The following connector has a tendency to stick in its socket. If so, insert a metal spudger into the gap between the connecter and its socket. Twist the spudger to separate the two components.
[* black] Carefully pull the optical drive connector away from its socket on the logic board.
[* icon_note] Pull the connector perpendicular to the face of the logic board.