Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #6

Edit by Scott Dingle

Edit approved by Scott Dingle

Before
After
Unchanged

Step Lines

[* black] Disconnect the LCD thermal sensor cable connector from its socket on the logic board.
[* black] Carefully pull the display toward the top edge oficon_note] If your iMac and lift it out offan is spinning full speed after completion, check this connection or the outer case, minding any cables that may get caughthard drive's thermal sensor cable.
[* black] Carefully pull the display toward the top edge oficon_note] If your iMac and lift it out offan is spinning full speed after completion, check this connection or the outer case, minding any cables that may get caughthard drive's thermal sensor cable.