Skip to main content

Changes to Step #5

Edit by iRobot

Pending approval

Before
After
Unchanged

Step Lines

[* icon_note] The 3.5 mm Phillips screw indicated below with a red circle may be absent in some models.
[* black] Remove the following 5 screws and 3 nuts from the heat sink:
[* red] One 3.5 mm Phillips from the lower left corner of the heat sink.
[* orange] Three 6 mm Phillips from around the fan.
[* yellow] One 7.5 mm Phillips at the top right corner of the heat sink.
[* green] One 4 mm nut from the side of the heat sink.
[* blue] Two 4 mm screw nuts with attached springs from either side of the heat sink.

Image 1

No previous image

Added