Skip to main content

Changes to Step #7

Edit by Walter Galan

Edit approved by Walter Galan

Before
After
Unchanged

Step Lines

-[* black] Remove the following screws securing the exhaust duct and logic board to the rear case:
+[* black] Remove the following screws securing the exhaust duct to the rear enclosure:
[* red] Two 6.3 mm T8 screws
[* orange] Two 4.7 mm T8 screws
- [* yellow] Four 7.2 mm T10 screws on the logic board
-[* icon_caution] Remove the exhaust duct screws before the logic board screws, to prevent putting stress on the heat sink heat pipes.

Image 2

Deleted