Skip to main content

Changes to Step #7

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

-[* black] Remove the following screws securing the logic board and exhaust duct to the rear case:
+[* black] Remove the following screws securing the exhaust duct and logic board to the rear case:
+ [* red] Two 6.3 mm T8 screws
+ [* orange] Two 4.7 mm T8 screws
+ [* yellow] Four 7.2 mm T10 screws on the logic board
+[* icon_caution] Remove the exhaust duct screws before the logic board screws, to prevent putting stress on the heat sink heat pipes.

Image 1

Old Version

New Version

Image 2

No previous image

Added