Skip to main content

Changes to Step #12

Edit by Chris Green

Pending approval

Before
After
Unchanged

Step Lines

+[* red] Remove these phillips screws:
+[* icon_reminder] To remove all 6, you will need to slide the sliding assembly to get to the center two screws.
+[* black] Now, using a spudger, or flathead screwdriver, seperate the two halves of the assembly, threading the data cable through it's hole.
+[* icon_note] This may take a little force since a mild adhesive is applied around the rim.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added