Skip to main content

Changes to Step #3

Edit by iRobot

Pending approval

Before
After
Unchanged

Step Lines

+[* black] Remove the following 7 screws from the edges of the keyboard area.
+ [* red] Three 2 mm Phillips along the right edge.
+ [* orange] One 4.5 mm Phillips underneath where the magnet was.
+ [* yellow] One 6 mm Phillips with a small head in the lower left corner.
+ [* green] Two 6 mm Phillips with large heads, one in the upper left corner and one in the middle

Image 1

No previous image

Added