Changes to Step #2
Edit by Walter Galan —
Edit approved by Walter Galan
- Before
- After
- Unchanged
Step Lines
| - | [* black] Walk the camera cable connector out of its socket with the tip of a spudger. |
|---|---|
| + | [* black] Disconnect the camera cable connector out of its socket with the tip of a spudger. |
| + | [* icon_note] It is recommended to carefully push on both sides of the connector to "walk" it out of its socket. |
| [* black] Pull the camera cable parallel to the face of the I/O board toward the front edge of the Air to disconnect it from its socket. | |
| [* icon_caution] Do not lift upward on this cable as you disconnect it, as its socket may break off the logic board. |