Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #7

Edit by Sam Goldheart

Edit approved by Sam Goldheart

Before
After
Unchanged

Step Lines

[* black] Logic board remains.
[* icon_reminder] When reassembling your logic board, be sure the rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins.
[* icon_note] The rubber gasket should attach to the end of the heat sink as seen in the secondthird picture.
[* icon_note] The rubber gasket should attach to the end of the heat sink as seen in the secondthird picture.