Skip to main content

Changes to Step #7

Edit by Walter Galan

Edit approved by Walter Galan

Deleted
Added
Unchanged

Step Lines

[* black] Logic board remains.
[* icon_reminder] When reassembling your logic board, be sure the rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins.
[* icon_note] The rubber gasket should attach to the end of the heat sink as seen in the second picture.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added