Changes to Step #7
Edit by Dominik Schnabelrauch —
Edit approved by Dominik Schnabelrauch
- Before
- After
- Unchanged
Step Lines
| - | [* black] With one half of the ear (1) fully disassembled we're keen |
|---|---|
| + | [* black] With one half of the ear (1) fully disassembled we're keen to finally check out the button cell ... |
| [* black] ... and we're stopped by two cables clenching the cell tight in their soldered embrace. | |
| [* black] A soldered battery makes a repair way more complex than we would wish for. At this point a battery replacement might be possible but requires extreme delicate soldering work. | |
| [* black] We leave the battery alone for a second and remove its plastic brace instead. Embedded in it we find the main magnet which holds the headphone in its charging position within the case. | |
| [* black] Since there is nothing left in the white head we administer to the fancy looking see through part with the board in it. | |
| [* black] Excepting the worst we're surprised to lever the headphone tail open rather quickly. A little bit of heat and a good old opening tool grants access to the remaining components. |