Changes to Step #13
Edit by Sam Omiotek —
Edit approved by Sam Omiotek
- Before
- After
- Unchanged
Step Lines
+ | [* black] Insert the point of a pick under the display where you just stopped cutting. Do not insert the pick deeper than the edge of the bezel. |
---|---|
+ | [* black] Carefully roll the pick to the right, pressing the long edge of the pick into the screen adhesive underneath the bezel, cutting the adhesive as you go. Do not slide the pick along the edge of the Surface. |
+ | [* black] Repeat this motion of inserting the point of the pick where you just cut, and rolling to the right all along the top edge of the Surface, until the pick is 2.5 inches (64 mm) from the right edge of the Surface. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added