Skip to main content

Changes to Step #2

Edit by Kyle Smith

Edit approved by Kyle Smith

Before
After
Unchanged

Step Lines

[title] Mark the hole location
[* black] Rotate the AirTag so that the CE marking is upright.
[* red] Use a marker or pen to draw a dot where you want to drill the keyring hole.
[* icon_note] Draw the dot as close to the edge of the gray battery compartment as possible. This will allow you to reattach the battery compartment door while the keyring is attached.
[* icon_note] The three potential drill locations are at the left (moving clockwise) end of each battery compartment clip hole.
[* icon_note] The three potential drill locations are at the left (moving clockwise) end of each battery compartment clip hole.
[* icon_note] You can locate our recommended drill location by drawing a dot at roughly seven o'clock.