Skip to main content

Changes to Step #2

Edit by Kyle Smith

Edit approved by Kyle Smith

Before
After
Unchanged

Step Lines

[title] Mark the hole location
[* black] Use a marker or pen to draw a dot where you'll be drilling the keyring hole.
[* icon_note] Draw the dot as close to the edge of the grey battery compartment as possible. This will allow you to place the battery compartment door while the keyring is attached.
[* icon_note] The potential drill locations are at the left, outerleft (moving clockwise) end of each battery compartment clip hole.
[* icon_note] Alternatively, you can locate theour recommended drill location by rotating the AirTag so that the CE marking is upright. Then, mark the holedrill location at roughly seven o'clock.
[* icon_note] The potential drill locations are at the left, outerleft (moving clockwise) end of each battery compartment clip hole.
[* icon_note] Alternatively, you can locate theour recommended drill location by rotating the AirTag so that the CE marking is upright. Then, mark the holedrill location at roughly seven o'clock.