Skip to main content

Changes to Step #1

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Before
After
Unchanged

Step Lines

[title] Loosen the adhesive
[* icon_note] The black foil which covers the display connectors is very fragile and likely to rip. To keep the tape intact while peeling it off, it's necessary to use high isopropyl alcohol or an iOpener.
[* black] [guide|11677|Prepare an iOpener|new_window=true] (or use a hair dryer or heat gun) and heat the face of the watch to loosen the adhesive tape.
[* icon_note] You may need to reheat the iOpener and repeat this procedure several times until adhesive softens.
-[* black] Alternatively, apply a little bit of high-concentration isopropyl alcohol (>99%) to a Q-tip and apply it to the black adhesive foil on top of the display connectors. Let it penetrate the adhesive for about two minutes.
+[* black] Alternatively, apply a little bit of high-concentration isopropyl alcohol (>90%) to a Q-tip and apply it to the black adhesive foil on top of the display connectors. Let it penetrate the adhesive for about two minutes.