Skip to main content

Changes to Step #8

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[* black] Place the watch on a flat surface and use an opening pick to slice through any remaining adhesive.
+ [* icon_caution] Try not to slice near the watch crown to prevent damaging the display cables. If you must slice near the crown, don't insert the opening pick deeper than 1/16th of an inch (~2 mm).
+[* black] Slide an opening pick under the opposite display edge of the watch crown.
+[* icon_caution] Don't try to remove the display. It is still connected to the watch assembly.