Skip to main content

Changes to Step #4

Edit by Kyle Smith

Edit approved by Kyle Smith

Before
After
Unchanged

Step Lines

[title] Cut along the perimeter of the rear cover
-[* black] Repeat the previous heating and cutting procedure for the remaining three sides of the phone.
-[* black] Leave an opening pick in each corner as you continue to the next to prevent the adhesive from resealing.
-[* icon_note] The rear cover will begin to separate from the phone as you finish all sides of the phone.
- [* icon_note] If the rear cover doesn't fully separate from the phone, use an opening pick to try cutting through the adhesive again.
+[* black] Repeat the process of heating and cutting the adhesive along the three remaining sides of the rear cover.
+ [* icon_note] You can insert each new opening pick in the gaps created by the opening picks left in each corner.
+[* black] As you proceed, leave an opening pick in each corner to prevent the adhesive from re-sealing.
+[* icon_note] If the rear cover is still attached to the phone after cutting through all four sides, try slicing through the adhesive again with an opening pick.