Skip to main content

Changes to Step #4

Edit by Sam Omiotek

Edit approved by Sam Omiotek

Before
After
Unchanged

Step Lines

[title] Guide the opening pick under the OLED panel
-[* icon_note] This step shows how to insert the pick without damaging the OLED panel. Do this before slicing the adhesive.
+[* icon_note] This step shows how to insert your pick without damaging the OLED panel. Do this before slicing the adhesive.
[* black] With the pick ***1 mm*** into the gap, pivot the pick upwards to a steep angle.
[* black] At a steep angle, carefully push the pick into the gap about 1/4 inch (6 mm). The pick should slide in ***below*** the OLED panel.
[* icon_caution] ***Stop if you feel the point of the pick hitting a ridge.*** The pick may be pressing against the edge of the OLED panel. Angle the pick and try again.