Skip to main content

Changes to Step #26

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Before
After
Unchanged

Step Lines

+[* black] The 2.39 Wh battery lives next to the driver on the backside. Long wires connect to a control board—but the connection is soldered.
+[* black] Mixed news: The headband has screws for removal, but doesn't fully detach without desoldering. Better news: the 2.5 mm aux jack is modular, held down with screws.
+[* black] Bad news: the microphones are embalmed in glue. Other bad news: the USB-C control board is modular, but held down with plastic rivets for some reason?
+[* black] To sum it all up:
+ [* green] Ear cushions, drivers, 2.5 mm aux jack, and buttons are accessible and replaceable.
+ [* yellow] The battery is easily accessible, but gluey—and its connection to the circuit board in the left ear cup is soldered.
+ [* red] Lots o' hot glue prevents microphones and some peripheral circuitry from being removed; the USB-C port is held down with single-use fasteners; the headband is a little confusing to disconnect and can't be fully removed without (extensive) soldering.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added