Fix Your Stuff

Right to Repair

Store

Changes to Step #2

Edit by Markus —

Edit approved by Markus

Before
After
Unchanged

Step Lines

[title] Fan assembly
[* yellow] The fan and air guidance assembly is attached to the main PCB with 2 screws.
[* orange] Each fan has one connector for power and one for the pod readersensor - these need to be disconnected from the PCB before removing the fan assembly. If you want to replace a fan, you will need to unhook the sensor cables from the sides.
[* orange] Each fan has one connector for power and one for the pod readersensor - these need to be disconnected from the PCB before removing the fan assembly. If you want to replace a fan, you will need to unhook the sensor cables from the sides.
[* black] Fans used are: '''1604KL-01W-B39'''-B00 NMB Technologies DC Fans DC Axial Fan, 40x10mm, 5VDC, 4.2CFM