Changes to Step #12
Edit by Arthur Shi —
Edit approved by Arthur Shi
- Before
- After
- Unchanged
Step Lines
| [title] Install the bottom adhesives | |
| - | [* red] To avoid blocking the microphone port with adhesive, strip 4R must be modified before use. A small notch must be cut out of the lower edge of the adhesive strip to accommodate the microphones. |
| + | [* icon_note] The next few steps will show you how to install the bottom right adhesive strip (strip 4R), which contains a notch that must be aligned for the microphone to function properly. |
| + | [* icon_caution] Read through this step and the next four steps before you attempt the procedure. |
| + | [* black] Grasp the red pull tab on strip 4R and pull to separate about 2 inches (5 cm) of white backing from the strip. |
Image 1
Old Version
New Version
Image 2
No previous image
Added
Image 3
No previous image
Added