Skip to main content

Changes to Step #18

Edit by Adam O'Camb

Edit approved by Adam O'Camb

Before
After
Unchanged

Step Lines

+[* black] With both plastic cards inserted as shown near the corners, gently twist the cards sideways to increase the gap between display and case.
+[* icon_note] If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the remaining adhesive.
+[* black] Begin to lift the top of the display up from the frame.
+[* icon_caution] Only lift the display a few inches—the display data and power cables are still connected to the logic board.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added