Skip to main content

Changes to Step #4

Edit by Phryne

Edit approved by Phryne

Before
After
Unchanged

Step Lines

+[title] Chip Removing
+[* black] Now we need to remove the touch module on the original screen and solder it onto the new replacement screen.
+[* black] Remove the earpiece speaker and sensor flex cable on the original screen. Then put a piece of paper under the touch flex cable. Heat with Hot Air Gun and pry up the touch module on the original screen.
+[* black] Then apply low-temp solder paste to the touch module. Heat with Soldering Iron at 365℃ to clean residual solder paste and black adhesive. Clean thoroughly with Solder Wick afterwards. Then clean with PCB Cleaner.
+[* black] Continue to get the touch module reballed.

Image 1

No previous image

Added