Skip to main content

Changes to Step #14

Edit by Arthur Shi

Edit approved by Arthur Shi

Before
After
Unchanged

Step Lines

[title] Separate the Top Edge Adhesive
-[* icon_caution] The glass near the corners of the back cover is curved, and very susceptible to cracking. Take care and be gentle during this step to prevent damaging your back cover panel.
-[* black] Gradually slide the pick from the right edge of the device around the top right corner. Continue cutting along the top edge to fully separate the back cover adhesive.
- [* icon_note] If at any point the cutting becomes difficult, reapply heat before continuing.
+[* icon_caution] The glass near the corners of the back cover is curved and very susceptible to cracking. Be gentle during this step to prevent damaging your back cover.
+[* black] Gradually slide the pick from the right edge of the device around the top right corner.
+[* black] Continue cutting along the top edge to fully separate the back cover adhesive.
+ [* icon_note] If the cutting becomes difficult at any point, reapply heat before continuing.