Skip to main content

Changes to Step #7

Edit by Carsten Frauenheim

Edit approved by Carsten Frauenheim

Before
After
Unchanged

Step Lines

+[* red] Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly.
+[* orange] Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.
+ [* icon_caution] These small screws can strip easily, so make sure your P2 pentalobe driver is in good condition before applying pressure.

Image 1

No previous image

Added

Image 2

No previous image

Added