Skip to main content

Changes to Step #1

Edit by elitree

Pending approval

Before
After
Unchanged

Step Lines

[* black] Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:
[* red] Seven 3 mm Phillips screws.
[* orange] Three 13.5 mm Phillips screws.
+[* black] Note the angle of the different screws, so that they may be reinserted at the correct angle after the repair is done:
+ [* black] Six of the seven 3mm screws are screwed in at an angle approximating the curve of the housing.
+ [* black] The 3mm screw at the rear of the unit (next to the 13.55 mm screws) is screwed in flat, as are the 13.55 mm screws.