Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #9

Edit by William Bennett

Edit approved by William Bennett

Before
After
Unchanged

Step Lines

[* black] Hold the housing and tape above the plastic axle so that the axle is concentric to the hole. Pinch the middle of the spring and slide the creased end through the gap in the middle of the axle. Push the whole mechanism down into the shell of the tape measure until it is flat against the plastic.
[* blackgreen] Place the black brake button into the bottom of the shell before closing it.
[* blackgreen] Place the black brake button into the bottom of the shell before closing it.
[* icon_caution] If creased end of spring is not put into the gap in the axle the spring will not be able to reel in the tape.

Image 3

Old Version

New Version