Skip to main content

Changes to Step #12

Edit by Josh Wright

Edit approved by Josh Wright

Deleted
Added
Unchanged

Step Lines

[* black] Use some isopropyll to remove the old Thermal Grease/Compound from the heat sink.
[* black] Apply A little amount of Thermal Compound to the Copper part of the cooling unit in the same positioning as the last. A miniscule amount, just enough to create a tiny layer.
[* black] Screw in the Cooling unit/Heat sink. screwScrew the 2 bottom screws first then the top screwscrew.
[* black] Plug the wires from the Cooling Fan back into the Mother Board.
[* black] Screw in the Cooling unit/Heat sink. screwScrew the 2 bottom screws first then the top screwscrew.
[* black] Plug the wires from the Cooling Fan back into the Mother Board.
[* black] There you have it :) Your new Processor is installed