Skip to main content

Changes to Step #11

Edit by Josh Wright

Edit approved by Josh Wright

Deleted
Added
Unchanged

Step Lines

[* black] Insert the new Processor
[* black] Twist the screw Clockwise Back into its original position (So the black point is pointing right)
[* black] Use isopropyll to clean the processor is necessary
[* black] Twist the screw Clockwise Back into its original position (So the black point is pointing right)
[* black] Use isopropyll to clean the processor is necessary
[* black] Open up the thermal Compound and apply it to the shiny reflective part of the new processor ( Do not use lots only a little is needed but ensure that the whole of it is covered) USE A PAINTBRUSH IF NECESSARY
[* black] It should look just about like the second Photo but it will differ in colour and positioning.
[* black] It should look just about like the second Photo but it will differ in colour and positioning.
[* black] Use some Isopropyl to remove the old thermal grease from the cooling unit.

Image 1

No previous image

Added