Skip to main content

Changes to Step #10

Edit by Josh Wright

Edit approved by Josh Wright

Deleted
Added
Unchanged

Step Lines

[* black] Unplug the wires connected to the logic board from the Cooling FanFan.
[* black] Unscrew the three screws (Boxed In Red)Red).
[* black] Unplug the wires connected to the logic board from the Cooling FanFan.
[* black] Unscrew the three screws (Boxed In Red)Red).
[* black] Lift out the Fan and the heat sink it is attached to.
[* black] Twist the screw slightly to the left, so that the pointed black plastic point looks like picture 3. It will not come out easily if this is done wrong so check, check then check again.
[* black] Lift out the processor carefullycarefully.
[* black] Lift out the processor carefullycarefully.