Skip to main content

Changes to Step #10

Edit by Josh Wright

Edit approved by Josh Wright

Deleted
Added
Unchanged

Step Lines

[* black] Unplug the wires connected to the logic board from the Cooling Fan
[* black] Unscrew the three screws (Boxed In BlueRed)
[* black] Lift out the Fan and the thing its connected toheat sink it is attached to.
[* black] Twist the screw slightly to the left, so that the pointed black plastic point looks like picture 3. It will not come out easily if this is pointed in the opposite direction to where it was before being unscreweddone wrong so check, check then check again.
[* black] Unscrew the three screws (Boxed In BlueRed)
[* black] Lift out the Fan and the thing its connected toheat sink it is attached to.
[* black] Twist the screw slightly to the left, so that the pointed black plastic point looks like picture 3. It will not come out easily if this is pointed in the opposite direction to where it was before being unscreweddone wrong so check, check then check again.
[* black] Lift out the processor carefully

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added