Skip to main content

Changes to Step #3

Edit by Josh Wright

Edit approved by Josh Wright


Step Lines

[* black] Remove the screws holding the Hard Drive in place (Boxed in Red)
[* black] Remove the screws holding the Optical drive in place (Boxed in Pink)
[* black] Remove the Memory Module (boxed in Blue)
[* black] Remove the screw holding the Wireless card and then remove the wires going into the wireless card by gently pulling them out. Then remove the wireless card (Boxed in Green)
[* black] Add screws to the appropriate bag
[* black] Disconnect the cable connected to the logic board near to the Wireless Card (Boxed in Yellow)