Skip to main content

Changes to Step #3

Edit by Josh Wright

Edit approved by Josh Wright

Deleted
Added
Unchanged

Step Lines

[* black] Remove the screws holding the Hard Drive in place (Boxed in Red)Red). Then remove the Hard Drive
[* black] Remove the screw holding the Optical drive in place (Boxed in Pink)
[* black] Remove
Pink). Then slide the Memory Module (boxed in Blue)optical drive out, following the Pink Arrow
[* black] Remove the screwscrews holding the Wireless card (Boxed in Green) and then remove the wires going into the wireless card by gently pulling them out. Then remove the wireless card (Boxed in Green)up, take care not to apply too much pressure, use a Safe Open Tool if you are afraid of damaging them.
[* black] Add screws toRemove the appropriate bagWireless Card by gently removing it from it's slot.
[* black] Disconnect the cable connected to the logic board near to the Wireless Card (Boxed in Yellow) by gently pulling up
[* black] Remove the screws holding the Hard Drive in place (Boxed in Red)Red). Then remove the Hard Drive
[* black] Remove the screw holding the Optical drive in place (Boxed in Pink)
[* black] Remove
Pink). Then slide the Memory Module (boxed in Blue)optical drive out, following the Pink Arrow
[* black] Remove the screwscrews holding the Wireless card (Boxed in Green) and then remove the wires going into the wireless card by gently pulling them out. Then remove the wireless card (Boxed in Green)up, take care not to apply too much pressure, use a Safe Open Tool if you are afraid of damaging them.
[* black] Add screws toRemove the appropriate bagWireless Card by gently removing it from it's slot.
[* black] Disconnect the cable connected to the logic board near to the Wireless Card (Boxed in Yellow) by gently pulling up

Image 1

No previous image

Added