Skip to main content

Changes to Step #7

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

[title] Install 1e.
-[* black] Insert wisdom here.
+[* orange] Plug the small end connector into the probe. It will only plug in one way so do not force it.
+[* green] Install the probe as shown with the connection facting the hot end. Use an M2 hex to install the provided M3x6 screws.
+[* yellow] You can now install the pre-crimped wires into the phoenix connector. Match the color order from the motherboard side.
+ [* icon_note] After tigtening all screws, give each wire a gentle tug to make sure they are tight.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version