Skip to main content

Changes to Step #4

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

+[* yellow] If you're going to glue the new connections in, do it now.
+[* black] Install the male green phoenix connector onto harness A.
+ [* violet] Using a flat head screwdriver, loosen the terminals 3-4 turns then insert the wires into the
+ [* icon_note] Color order does not matter but the other side of the harness HAS to match.
+ [* icon_note] When tightening the screw terminals, feel for when the wire end is contacted and do not overtighten. Give each wire a very gentle pull to test that they are all firmly connected.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added