Skip to main content

Changes to Step #4

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

[* yellow] If you're going to glue the new connections in, do it now.
[* black] Install the male green phoenix connector onto harness A.
[* violet] Using a flat head screwdriver, loosen the terminals 3-4 turns then insert the wires into the
- [* icon_note] Color order does not matter but the other side of the harness HAS to match.
- [* icon_note] When tightening the screw terminals, feel for when the wire end is contacted and do not overtighten. Give each wire a very gentle pull to test that they are all firmly connected.
+ [* icon_note] Color order does not matter but the other side of the harness HAS to match. When tightening the screw terminals, feel for when the wire end is contacted and do not overtighten. Give each wire a very gentle pull to test that they are all firmly connected.
+[* orange] Reinstall the power supply and tighten the screws.
+[* yellow] Reinstall the bottom cover and tigthen the screws.
+ [* icon_note] The vent holes should be positioned over the power supply.

Image 2

Old Version

New Version

Image 3

Old Version

New Version