Skip to main content

Changes to Step #3

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

-[* yellow] After feeding the short harness into the control box, note where everything is connected in case you have remove things like the LCD connections to access the new connection points.
+[* yellow] After feeding harness A into the control box, note where everything is connected in case you have remove things like the LCD connections to access the new connection points.
[* green] Plug in the 3 pin connector to D11 row with the red wire on the V pin. For CR-10S machines, it is the pin closest to the LCD connections.
[* icon_note] Unplug the Z end stop wires from the motherboard (not shown)
[* orange] Plug in the 2 pin connector where the original Z end stop was plugged in. This is Z- for CR-10S machines.
[* icon_note] Hot glue is optional.
-[* light_blue] Zip tie the newly added harness to the original harness group for strain relief.
+[* light_blue] Zip tie harness A to the original harness group for strain relief.