Skip to main content

Changes to Step #2

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

-[title] Disassembly
+[title] Install 1a.
[* orange] With the grommet loose, you can feed harness A through the grommet with the 2 and 3 pin connector going first.
[* icon_note] Feed it through the hole in the rear of the control box.
[* light_blue] Leave 4-5 inches of the loose pins and reinstall the grommet.
[* icon_note] Make sure the grommet is fully seated into the hold.