Skip to main content

Changes to Step #2

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

+[* orange] With the grommet loose, you can feed the 2 and 3 pin connector through the grommet and feed it through the hole in the rear of the control box.
+[* light_blue] Leave 4-5 inches of the loose pins and reinstall the grommet.
+[* black] Make sure the grommet is fully seated into the hold.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added