Skip to main content

Changes to Step #1

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

+[title] Disassembly
[* icon_caution] Before you begin...
[* red] Turn the power switch to OFF
[* orange] Unplug the power cable
[* yellow] Using an M2 hex, remove the 5 button head screws holding the control box bottom cover on.
[* yellow] using an M2.5 hex, remove the 4 button head screws holding the power supply to the control box.
[* green] Lay the power supply to the side as shown.
[* violet] Remove the grommet from the rear of the control box and pull back a few inches as shown.