Skip to main content

Changes to Step #1

Edit by Tiny Machines 3D

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

+[* icon_caution] Before you begin...
+ [* red] Turn the power switch to OFF
+ [* orange] Unplug the power cable
+[* yellow] Using an M2 hex, remove the 5 button head screws holding the control box bottom cover on.
+[* yellow] using an M2.5 hex, remove the 4 button head screws holding the power supply to the control box.
+[* green] Lay the power supply to the side as shown.
+[* violet] Remove the grommet from the rear of the control box and pull back a few inches as shown.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added